Got my stick plate almost ready. Not installed yet because I need to attach a copper coil or copper plate to the bottom of it. I am alo going to be installing some wire that will run from the bottom of the stick plate into the orgone mix that will fill box. Also I have included the Dragons Eye seal which will help attune the box to certain frequencies and vibrations and also allow me to use the box as a portal to work with entities to help with my work. Getting holes drilled out now for my dials. But so far everything is coming along nicely. Also got the scalar field generator installed completely now to. Also installed an additional MWO antenna to help broadcast the energy from the Orgone to the top MWO antenna.
top of page
Pour tester cette fonctionnalité, accédez à votre site en ligne.
Progress on my Radionic Box
Progress on my Radionic Box
4 commentaires
J'aime
4 commentaires
bottom of page
I'm thrilled to share the progress on my Radionic Box, as it's been a fascinating journey of exploration and discovery. With each component carefully calibrated and meticulously assembled, the device is gradually coming together to form a complex yet elegant system. The Index of achievements showcases the milestones reached, highlighting the intricate details and innovative solutions incorporated into the design. Through meticulous testing and refinement, I'm witnessing the tangible results of my efforts, reaffirming my belief in the potential of this technology. As I continue to fine-tune and optimize the setup, I eagerly anticipate unlocking its full potential and experiencing the transformative effects it promises to deliver.
I dig the Crystal Power book! Nice work!
So as of recent I went back to this box and decided I wanted to tone it down and give it more functionality without all of that antenna work that I was doing. The following photos are my finished box along with other devices I've been hard at work on.
Excellent work, thank you very much for sharing!
Your project will work wonderfully, I am confident of it.